Shenzhen Sai Tong Tian Electronic Technology Co.,Ltd

GSM900*DCS 1800mhzDual band Signal Booster Signal Repeater for home/office use ST1090A Repeater Max coverage 100sqm 

What is the Cell phone Signal booster?

Cell phone becomes especially helpful when people get into critical situations. In case of emergency a timely call can save somebody’s life.

Unfortunately, there are still some places where one can find themselves “out of coverage”. Usually those placesare either too far from the cell phone base station or located inside underground constructions, for example:

Parking lots, tunnels

Big stores, office buildings

Cars, boats etc.

House in remote areas etc

How is mobile phone signal booster WORKING ?

The outside antenna catches the low signal from the mobile base station and delivers it to the cell phone 

amplifier through the connection cable (coax).

After the signal is accepted by the phone amplifier, the device amplifies it.

Then this amplified signal goes through the connection cable (coax) to the inside antenna.

And after that, the amplified signal transmits to the cell phone.

ST1090A mobile phone signal booster specification

ST-1090A Outside picture/Inside Design

ST-1090A Outside picture/Inside Design

Mobile Phone signal Booster Installation complete kit items

What is the package Included?

1 x 65dB Repeater  FOR gsm signal booster 

1 x 8dBi Gain Outdoor Yagi Antenna  FOR gsm signal booster 

1 x 3dBi Gain Indoor Ceiling Antenna FOR gsm signal booster 

1 x 5 Meters Low-loss Coaxial Cable for connecting indoor Antenna

1 x 15 Meters Low-loss Coaxial Cable for connecting outdoor Antenna

1 x AC Adapter FOR gsm signal booster 

4 x Screws for Mounting Signal Booster FOR

Signal Booster Installation diagram (very convenient and easy to install)

How should you install signal booster (very easy and simple):

Step 1:Use your mobile phone to test signal strength outside house or on roof, -70dbm is the basic requirement (full bar). 

Step 2 Install outdoor antenna in that location and keep adjusting, point it to signal tower station, try to get best signal.

Step 3:Run outdoor coaxial cable into building in a convenient location to connect with signal repeater.

step 4:Mount your indoor antenna with signal repeater

step 5:Power up signal repeater device to check the signal inside, moving outdoor antenna until you get satisfied signal.

Note: Connect outdoor (BTS) port with outdoor antenna, connect indoor ANT(MS) port with indoor antenna, outdoor antenna is mounted at a higher position. Both antennas should be 10 meters far away from each other at least.

Indoor and outdoor antenna must be separated by wall.

Terms and Conditions

Mobile Phone Signal Repeater Installation Steps

Step 1: Install the outdoor antenna in a suitable place

Step 2: Connect the outdoor antenna to the booster “outdoor” side by cable and connector

Step 3: Connect the indoor antenna to the booster “indoor” side by cable and connector

Step 4: Connect to the power

Features

Elegant appearance, mini size, light weight

Easy installation.

No interference to the base station, no harm to people health.

CE & RoHS proved.

Low consumption.

ALC technology.

Stable performance.

Environment Friendly, Energy-Efficient.

Comply to the ETS300 694-4 standard 

Comply to the GB6993-86 standard

Wide band repeater to support signals of all operators.

High-integration (One board to contain low-noise amplifier, frequency selection module, power amplifier module, both uplink and downlink one for all).

Manual gain control, Automatic gain control, Artificial Intelligence function can protect the repeater together the BTS perfectly.

Auto shut off function as final step to avoid severe interference with mobile net network and energy saving.

LED Indicates